Slate Bathroom floor and walls - Complete Care Guide
Slate Bathroom floor and walls - Complete Care Guide
From installation to daily maintenance: everything you need to know
Initial Care (After Installation)
When: Within 1 week of installation, after grout has cured.
- Clean the new slate surface with Lithofin MN Power-Clean diluted 1:10 to remove any installation residues.
- Rinse thoroughly with clean water and allow to dry completely (24-48 hours).
- Apply Lithofin MN Stain-Stop evenly with a soft cloth or sponge.
- Remove excess after 10-15 minutes.
- Allow 24 hours to cure before using the bathroom.
Products needed: Lithofin MN Power-Clean, Lithofin MN Stain-Stop
Daily Maintenance
Frequency: Daily or after each use
- Wipe the slate surface with a damp cloth using Lithofin MN Easy-Clean (spray) or MN Wash & Clean (diluted in water).
- Clean spills immediately - especially soap, shampoo, and other bathroom products.
- Dry the surface after cleaning to prevent water marks.
Products: Lithofin MN Easy-Clean, Lithofin MN Wash & Clean
Do NOT:
- Never use vinegar or lemon-based cleaners.
- Never use abrasive sponges or steel wool.
- Never use bleach or chlorine-based cleaners.
- Do not leave acidic products sitting on the surface.
Periodic Deep Cleaning
Frequency: Every 1-3 months
- Apply Lithofin MN Power-Clean diluted 1:5 with a sponge.
- Leave for 5-10 minutes.
- Scrub gently with a soft brush.
- Rinse thoroughly with clean water.
- Dry with a soft cloth.
Products: Lithofin MN Power-Clean
Protection & Sealing
Re-seal every: Every 1-2 years (more frequent in high-use areas).
- Deep clean the surface first.
- Allow to dry completely (24-48 hours).
- Apply Lithofin MN Stain-Stop evenly with a soft cloth.
- Remove excess after 10-15 minutes.
- Allow 24 hours to cure before using the bathroom.
Products: Lithofin MN Stain-Stop
Need specific product advice?
Use our Lithofinder to find the exact right product, or learn more about Slate.