Limestone Bathroom surfaces (floor, walls, vanity) - Complete Care Guide
Limestone Bathroom surfaces (floor, walls, vanity) - Complete Care Guide
From installation to daily maintenance: everything you need to know
Initial Care (After Installation)
When: Within 1 week of installation, after grout has cured.
- Clean the new limestone surface with Lithofin MN Power-Clean diluted 1:10 to remove any installation residues.
- Allow the surface to dry completely (24-48 hours).
- Apply Lithofin MN Stain-Stop evenly with a soft cloth.
- Remove excess after 10-15 minutes.
- Allow 24 hours to cure before using the surface.
- For very porous limestone, apply a second coat of Stain-Stop after 30 minutes.
Products needed: Lithofin MN Power-Clean, Lithofin MN Stain-Stop
Daily Maintenance
Frequency: Daily or after each use
- Wipe the surface with a damp cloth using Lithofin MN Easy-Clean (spray) or MN Wash & Clean (diluted in water).
- Clean spills immediately - especially wine, lemon juice, coffee, and tomato sauce.
- Dry the surface after cleaning to prevent water marks.
Products: Lithofin MN Easy-Clean, Lithofin MN Wash & Clean
Do NOT:
- Never use vinegar or lemon-based cleaners.
- Never use abrasive sponges or steel wool.
- Never use bleach or chlorine-based cleaners.
- Never place hot items directly on limestone.
- Do not leave acidic substances sitting on the surface.
Periodic Deep Cleaning
Frequency: Every 1-3 months
- Apply Lithofin MN Power-Clean diluted 1:5 with a sponge.
- Leave for 5-10 minutes.
- Scrub gently with a soft brush.
- Rinse thoroughly with clean water.
- Dry with a soft cloth.
Products: Lithofin MN Power-Clean
Protection & Sealing
Re-seal every: Every 1-2 years (more frequent re-sealing may be required for high-use areas)
- Deep clean the surface first.
- Allow to dry completely (24-48 hours).
- Apply Lithofin MN Stain-Stop evenly across the surface.
Products: Lithofin MN Stain-Stop
Need specific product advice?
Use our Lithofinder to find the exact right product, or learn more about Limestone.