Marble Kitchen countertop - Complete Care Guide
Marble Kitchen countertop - Complete Care Guide
From installation to daily maintenance: everything you need to know
Initial Care (After Installation)
When: Within 1 week of installation, after grout has cured
- Clean the new surface with Lithofin MN Power-Clean diluted 1:10 to remove any installation residues
- Allow to dry completely (24-48 hours)
- Apply Lithofin MN Stain-Stop evenly with a soft cloth
- Remove excess after 10-15 minutes
- Allow 24 hours to cure before use
- On very porous marble, apply a second coat after 30 minutes
Products needed: Lithofin MN Power-Clean, Lithofin MN Stain-Stop
Daily Maintenance
Frequency: Daily or after each use
- Wipe surface with damp cloth using Lithofin MN Easy-Clean (spray) or MN Wash & Clean (diluted in water)
- Clean spills immediately - especially wine, lemon juice, coffee, and tomato sauce
- Dry the surface after cleaning to prevent water marks
Products: Lithofin MN Easy-Clean, Lithofin MN Wash & Clean
Do NOT:
- Never use vinegar or lemon-based cleaners
- Never use abrasive sponges or steel wool
- Never use bleach or chlorine-based cleaners
- Never place hot pans directly on marble
- Do not leave acidic foods sitting on the surface
Periodic Deep Cleaning
Frequency: Every 1-3 months
- Apply Lithofin MN Power-Clean diluted 1:5 with a sponge
- Leave 5-10 minutes
- Scrub gently with soft brush
- Rinse thoroughly with clean water
- Dry with soft cloth
Products: Lithofin MN Power-Clean
Protection & Sealing
Re-seal every: Every 1-2 years (kitchen use requires more frequent re-sealing)
- Deep clean the surface first
- Allow to dry completely (24-48h)
- Apply Lithofin MN Stain-Stop evenly
- Remove excess after 10-15 minutes
- Allow 24 hours before use
Products: Lithofin MN Stain-Stop
Troubleshooting
Etch marks (dull spots) from acid contact
Use Lithofin MN Polish Cream - apply a small amount, rub in circular motions with a soft cloth until shine is restored. For deep etching, repeat several times.
Oil or grease stain
Apply Lithofin OIL-EX as a thick paste, cover with cling film, leave 2-12 hours. Remove paste, clean with MN Wash & Clean. Repeat if needed.
Water rings from cups
These are often etch marks from condensation (slightly acidic). Use MN Polish Cream for polished marble. Re-seal after treatment.
General yellowing of white marble
May be caused by oxidation of iron minerals within the stone. Clean with MN Power-Clean. If persistent, this is a natural characteristic.
Need specific product advice?
Use our Lithofinder to find the exact right product, or learn more about Marble.